The minimal height of the unit allows it to be fitted within a ceiling void of 250mm. The maximum recommended mounting height is 3m.
Connection should be made to a suitably fused power supply via the remote switch unit or a 2 pole switched connection unit having a contact separation of at least 3mm in all poles. Access to the connector block is gained by opening the side cover plate (1 screw), connection is then made using cables with 4 cores and earth, with at least one being rated to take the full load current.
All electrical connections should be made by a suitably qualified person in accordance with the latest edition of the IEE Requirements for Electrical Installation (BS 7671:2008).
APPLICATIONS Recessed ceiling heaters are designed for installation into either a standard suspended grid or plasterboard ceiling, wherever there is sufficient space above to accommodate them.
The RCHS front panel can be cut down to a minimum 600mm x 400mm for use where the full 600mm x 600mm is not required, such as over door or perimeter use.
They can be installed as the main or supplementary heating in shops, reception areas, toilets etc.
For even heating a greater number of 3kW units is preferable over fewer 4.5kW units. Locating the units in positions of greatest heat loss gives an easy solution to uneven heating of open plan areas.
The high level mounting has the added benefit of re-circulating the hot air from ceiling level for greater heating efficiency.
Front mounted air intake ensures only pre-heated air from the room is re-circulated.
FEATURES Remote switching unit for 2 heat selection and fan only.
The RCHS front panel can be reduced to 600mm x 400mm for use where the full 600mm x 600mm is not available, such as over door or perimeter use. - -
Front mounted intake ensuring recirculation of room air only - Models for suspended T bar ceiling systems, standard plasterboard ceilings and surface mounting -
Minimum height for ease of installation in smaller ceiling voids - Light grey textured powder coated finish front cover (RAL7035) -
Front cover can be modified for non standard tiles Over temperature safety cut-out with power off reset Also available in ëTime and Temperatureí (ëTTí) versions.
White powder coated finish front cover (RAL 9003) ìTTî versions are configured to allow control via time clocks & Thermostats (not included)